Hitchgate Switch

The new Wilco HitchGate Switch offers more options, and better fitment. The Hitchgate Switch is designed to carry up to a 37" tire on a full size truck and has options to carry tons of gear.

The main difference between the Switch and the Standard Hitchgate:

• The Switch has an Integrated Bolt-Action lock-pin to hold gate open when at camp or parked on an incline
• Secondary Cargo Hitch on the swing arm to carry a bike rack or cargo rack comes standard
• Adjustable Wheel Mounting Plate allowing the tire to be set closer or further from the vehicle depending on wheel offset and gear load out
• Can carry up to a 37" Tire!

The Hitchgate Switch High Clearance (UHG4100) is the most popular product. Great for Midsize vehicles up to a 37”(4Runners, Tacoma's, Colorado's) and Full-Size up to 37”(Silverado's, Dodge Ram, Ford F150, F250, Sequoias, Etc.) *Raised 4.5"

The Hithgate Switch Low Profile (UHG4100-LP) is best for midsize vehicles where the bumper is molded around the hitch. (ex. Current body style Grand Cherokees). Subaru Outback & Crosstrek. *Sits 4.5" lower than the Switch

*Wedge Lock and all hardware included to install the Switch and Tire.

Identify that you have at least 4 ½” from your hitch pin hole towards the front of your vehicle. Doing so will ensure that the Hitchgate will be able to engage its wedge lock design eliminating any wobble or play in your receiver that you may have. 

Factors that can result in the receiver tubing not fitting can be caused by: 

• Receiver tubing has a plate on the back end of the receiver that restricts the hitchgate tubing from running back enough for the wedge lock to have room to engage or hitch pin holes to align.
• Some model vehicles have a muffler in the rear that interferes with how far back the tubing is allowed to run. This will require the muffler or exhaust components to be relocated.
• You want to make sure the face of your hitch receiver recedes no more than 1” behind your bumper. 

**Notice of maintenance required** - Periodic tightening of the pivot bolt with a torque wrench to at least 60-70lbs every few months is needed to prevent movement on the swing arm. Also, over time replacing the Delrin washers and T handle bushings.

Accessories You Can Add:

• License Plate Relocation Bracket (no light included, see below)
• License Plate LED Light
• Hitchgate Accessory Plate Kit
• 3-Gallon Rotopax (red) RX-3G (no pack mount included)
• 3.5 Gallon Rotopax FuelPax RX-3.5G (no pack mount included)
• 2-Gallon Rotopax (red) RX-2G (no pack mount included)
• Rotopax Deluxe Pack Mount RX-DLX-PM
• Rotopax LOX Pack Mount RX-LOX-PM
• Frontrunner Tailgate Table
• Rotopax Diesel Pack (no pack mount included)
• Rotopax Water Pack (no pack mount included)
• Rotopax Storage Pack (no pack mount included)
• Rotopax Emergency Storage (no pack mount included)